These pre-made Torch Coils are made by taking two different flat ribbon wires, wrapping a thin standard wire diagonally around one and then twisting the two together.
Our torch coils comprise of a length of 0.2mm x 0.8mm flat ribbon wire and tightly wrapping 32 gauge kanthal A1 around it. This resulting wire is then twisted together with 0.4mm x 1.0mm flat ribbon wire and then coiled at 0.2 ohms.
Pack of 10
Other Coil making essentials can be found here.
These products are meant for advanced users only and caution is advised. Please ensure that your device and batteries can handle low ohm builds. Lower resistance coils such as these have a higher amp draw. Due to the manufacturing process, the actual resistance may vary slightly from the stated resistance. A device with an ohm meter is advisable, especially to ensure there are no short circuits due to incorrect installation.