The Pre-made Alien Coils, as standard are a moderately complicated coil to produce. It is similar in some ways to a fused clapton, but with a difference. The wire used to wrap has already been coiled diagonally once around a core wire (or claptoned) and then removed and stretched out slightly. The resulting wire is once again coiled round a core to give the wrap a wavy pattern.
Our Alien coils use a 0.3mm x 0.8mm flat wire as the core with a 32 gauge kanthal A1 wrap. This is then coiled at 0.45 ohms.
A slight variation of this wire type is the Alien Clapton, which uses the same wire type for the wrap, but this is coiled around 3 x 26 gauge parallel lengths of kanthal wire.
Pack of 10
Other Coil making essentials can be found here.
These products are meant for advanced users only and caution is advised. Please ensure that your device and batteries can handle low ohm builds. Lower resistance coils such as these have a higher amp draw. Due to the manufacturing process, the actual resistance may vary slightly from the stated resistance. A device with an ohm meter is advisable, especially to ensure there are no short circuits due to incorrect installation.